I am always interested on your take on the industry and where things are headed. I look forward to reading your blog. How about “Dave’s Dogma”.

Regards,

Mike

Davey’s Locker

The Good Son

Shop Ramblings

Uncle Dave’s Notebook

Dave’s Diary

Shop Support

Industry Insider

Dave’s Observations

Winona Happenings

Goodson Green

The Supply Line

Dave’s Shop Talk

Straight Shootin’ with Dave

Dave Direct

Direct From Dave

The Performance Shop

Goodson Precision Room

Chatting with Dave

The Goodson Garage

Straight Talkin’ with Dave

Dave: most of these ideas may be a bit lame, but there may be a few possibles.

Glad to see you’re starting a blog. I don’t really think it’s selfserving to have something like this going on….look at what Dart Heads has done with their forum. It’s been a great tool for them. Most of the posters there do alot of the work for the Dart crew. One of the board members is even helping out with the administration of the board. I hot like the gas porting tool from there also. Take a look at what they are doing,…you guys may be able to do something like it. Would be a good place for customers to go and ask about tooling and how to use it.

http://www.dartheads.com/dartboard/index.php

As far as the coolest new tool I saw at the PRI show…………….well it has to be that new Hyper Finish Diamond Valve Guide Sizing System. This newly released tool allows the engine builder, to be in full control for size, maintaining round/straight bores, as well as delivering the finish that engine builders want on any guide material. Yes that is my final answer on what was the neatest or coolest tool I saw at PRI.

What was everybodies else’s opnion? Any other really cool tools that caught your attention?

Here’s what I want to know…what was the new tool that seemed to really capture just about everybody’s attention at the PRI Trade Show?

Best of luck on the new project, Dave.