« Piston C-clip installer
Spray Wash Cabinet? »

Interference fit

Im wondering how much of a interferance fit I will need for a .372ID x .502 OD bronze valve guide. This is a cast iron head.

Thanks
Perkovich

This entry was posted on Monday, October 19th, 2009 at 9:55 pm and is filed under General Engine Building. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Response to “Interference fit”

  1. Jim says:
    March 15, 2010 at 8:28 am

    Simply use the core drill and core ream for 3/8 X .500" The press fit will be on the replacement guide. You will have .002" plus or minus a small tolerance in tenths of a thousands.

Leave a Reply